Crime Guard 745i2, Installation Manual

Page: 31 / 44

31
Chrysler Positive Pulse Single Wire System
Specific Chrysler products utilize a resisted Positive Trigger Single Wire
door locking system. When the vehicle door lock switch is activated to lock or
unlock the doors, a positive (+)12 volt pulse is applied through one of two
resistors on the same wire that leads to the BCM. The BCM receives the signal
and reads the voltage. The vehicle door lock/unlock wire can best be picked
up in the driver’s side kick panel.
The following Chrysler products can be treated as a
(+)
single wire system:
1. The 1995-96 Chrysler Cirrus, Dodge Stratus, Plymouth Breeze &
Chrysler Sebring convertible incorporate this system.
2. The 1993-96 Chrysler Concord, New Yorker, LHS, Dodge Intrepid and
the Eagle Vision may be wired either as a positive single wire type or as
standard positive trigger type door lock system; however, the single
wire approach is recommended because of the difficulty in accessing
the positive trigger relays.
Vehicle wire location & colors:
Vehicle:
Cirrus / Stratus / Breeze Sebring convertible
Color :
White/Lite-Green White/Lite-Green
Plug :
Brown 16-pin 20-pin Connector
Location :
Drv’s kick panel BCM in Drv’s kick
Resistor Values:
Lock: 620 Ohm / Unlock: 2.7k Ohm
Vehicle:
New Yorker / Concord / LHS / Vision / Intrepid
Color :
Orange/Violet
Plug :
Blue or Black 16-pin
Location :
Drv’s kick panel
Resistor Values:
Lock: 2.7k Ohm / Unlock: 620 Ohm