13
PINK WIRE - (Negative Auxilary Output #2):
The function of the Pink wire
is to provide an optional output similar to the Gray trunk release wire. Pressing
the lower Small button for three seconds activates this output. Once activated,
this output will last for one second or for as long as transmitter button is held
down, with a maximum of 10 seconds. This function can be used to activate
other optional modules (Example: car starting equipment or power window
roll up units). For most applications an optional relay will be needed (Use the
diagram below for the Gray wire). This output will not disarm the security
system when activated.
OPERATE OPTIONAL TRUNK
RELEASE
OPERATE OPTIONAL
CAR-START MODULE
OPERATE OPTIONAL WINDOW ROLL-UPS
3
SECONDS
AUXILARY CHANNEL #2
P
ress & Hold The Lower Small Button For 3 Seconds.
Wiring An Optional Relay For Trunk Release.
Note: In Some Applications The Solenoid Wire Will Rest At Ground.
-Cut The Wire:
-Connect The Switch Side To Relay Pin 87a.
-Connect The Solenoid Side To Relay Pin 30.
-Connect (+)12 Volts To Relay Pin 87. (Fused)
Connect
To (+)12 Volts Or (-)Negative Ground As Needed in the
particular application. (In This Case Negative Is Required)
To (+)12
Volts
Release
Switch
Release
Solenoid
87
86 87a 85
Gray or Pink Wire
To (+)12 Volt
Positive
30
Control
Unit