Page 25
Feature #10 Unlock #2 When Ignition Is Turned Off
(Factory Default Setting Off)
Explained in the previous feature, if Driver’s Door Priority is installed this feature
controls the automatic unlocking when the ignition key is turned off of all doors
except the driver’s door. When programming, press the transmitter Upper Left
“Lock” Button to turn on Unlock #2 When Ignition turned Off”; or press the Upper
Right “Unlock” Button to turn it off.
Feature #11 Open Door Bypass Of Ignition Locking
(Factory Default Setting On)
This feature cancels the automatic locking or unlocking of the vehicle’s doors should
one of the doors is open when the ignition switch is turned on or off. When
programming, press the transmitter Upper Left “Lock” Button to turn on the “Open
Door Bypass”, or press the Upper Right “Unlock” Button to turn it off.
Feature #12 Doors Lock With Last Door Arming
(Factory Default Setting Off)
This feature adds the automatic locking of the doors to the Last Door Arming
operation. If this feature is added to feature #4, when the system becomes armed 30
seconds after closing the last door the doors will also lock . This feature will operate
only if feature #4 is turned on. When programming, press the transmitter Upper Left
“Lock” Button to turn on the automatic door locking, or press the Upper Right
“Unlock” Button to turn it off.
Feature #13 Doors Lock With Automatic Rearming
(Factory Default Setting Off)
This feature adds the automatic locking of the doors to the Automatic Rearming
operation. If this feature is added to feature #5, when the system rearms itself 90
seconds after being disarmed the doors will also lock. This feature will operate only
if feature #5 is turned on. When programming, press the transmitter Upper Left
“Lock” Button to turn on the automatic door locking, or press the Upper Right
“Unlock” Button to turn it off.
Feature #14 Ignition Activated Vehicle Recovery
(Factory Default Setting Off)
This form of Vehicle Recovery is initiated by the ignition key being turned on. The
Vehicle Recovery operation, and the three ways to initiate it are described on page
17. When programming this feature, press the transmitter’s Upper Left “Lock”
Button to turn it on, or press the Upper Right “Unlock” Button to turn it off.
alarm cycles. After the third alarm cycle the system will automatically rearm
and bypass the open zone until that zone returns to a non-violated state.
• Once the system resets after it has been activated, upon disarming the
audible and visual confirmation will change to indicate the activation.
This is the “Activation Alert”, which is explained on the next page.
There are two methods of Disarming the security system:
1-
The first is to press and release the transmitter’s Upper Right “Unlock”
Button to disarm the system. This is the normal “daily use” method.
2-
The second method is for emergencies, should the transmitter become
lost or inoperable. This is the “Emergency Override”, which uses the
ignition key and Valet Switch.
DISARMING THE SYSTEM
THE SIREN WILL CHIRP
ONCE TO CONFIRM
DISARMING
THE PARKING LIGHTS
WILL ILLUMINATE
TO CONFIRM
DISARMING
THE DOORS WILL UNLOCK;
Either All or Drivers Only
Upon Disarming:
✓
The siren will chirp once (or three times if an alarm activation occurred)
unless the silent disarming procedure is followed.
✓
The parking lights will flash once and then illuminate for 30 seconds, or
until the ignition key is turned on.
✓
The doors will unlock, either all doors or driver’s door only. If the sys-
tem is configured with “Driver Door Priority Unlocking”, simply press
the Upper Right “Unlock” Button again, and all of the doors will unlock.
✓
The starter interrupt will disengage.
✓
The Status Light will show one of these conditions:
-Off = System disarmed (Automatic Rearming feature not selected).
-Flashing rapidly = The Automatic Rearming feature is in progress.
-Flash /Pause = Indicates violated zone if system has been activated.
Page 8
To Disarm the System:
Press & Release the Upper Right
“Unlock” Button ( )
