3
© 2022 HALFEN · Inst_HLB 07/22 · www.halfen.com
HLB Assembly
Instructions
Deutsch
English
Fr
ançais
Polski
Adjustment, installation of additional reinforcement
Gap width:
Regular: 20 mm
Alignment of Loop Boxes:
Regular case: Loops aligned axially at the same level
Vertical tolerance: max.: 20 mm
Installation tolerances
according to offi
cial approvals, recommended also for applications as constructive connections.
Installation of additional reinforcement:
Additional reinforcement must be installed following
the reinforcement drawing and attached to the structural
reinforcement
.
Horizontal: Vertical:
Bar B500A, diam. 12 mm
A vertical tolerance of 20 mm maximum is permitted.
Wire binding of loops is not compulsory.
Bar B500A, diam. 10 mm
Stirrup B500A, diam. 8 mm, anchoring acc.
DIN EN 1992-1-1:2011-01 with
DIN EN 1992-1-1/NA:2013-04
Welding on HLB elements is not permitted !
Minimum: 10 mm
Maximum: 40 mm
1.
3.
4.
1. Precast
concrete ele-
ment with
closed HLB
Loop Box.
2. Remove the HLB Loop Box cover: loosen the
cover from the concrete as shown. Strike in the
pre-punched hole and pull out the steel cover.
Remove end covers (adhesive tape). If HLB
Spacers are used, they must be removed, using
an appropriate tool (e.g. a carpenters hammer).
3. Setting up the precast
element. All wire loops
must protrude perpendicu-
larly to the joint, and after
defl ection during the set-
ting up they should spring
back into this position.
4. Insert the reinforcement
bar diam. 12 mm and encase
the joint with an appropriate
formwork. Prepare the HLB
MIX joint grout according to
the manufacturers instruc-
tions. The maximum grouting
height is 3,5 m, or use a
hose. HLB MIX joint grout
is free fl owing, no additional
compaction is required.
2.
HLB
Spacer
On the construction site
max.
20 mm
