Crevalle Boats 24 Bay, Owner'S Manual

Page: 61 / 147

61
Electrical System
Recirculation Switch Panel (Optional)
FWD Recirc
Activates the pump that recirculates the water in
the forward baitwell below the console bench seat.
Port AFT Recirc
Activates the pump that recirculates the water in
the port aft release well/baitwell.
STBD AFT Recirc
Activates the pump that recirculates the water in
the starboard aft release well/baitwell.
Additional DC Switch Panels
Trim Tab Switch
Located in the helm. This switch panel controls
the trim tab planes located on the transom of the
boat. It is protected by a circuit breaker located
in the battery switch panel. Refer to the Helm
Control Systems chapter for detailed information
on the operation of the trim tab controls.
Jack Plate Switch
A lever style switch located on the steering wheel
bezel that controls the height of the engine on
the transom. Refer to the Helm Control Systems
chapter and the Jack Plate owner’s manual for
information regarding the proper use of the Jack
Plate control switch.
Power Pole Switch (Optional)
Located in the helm. Controls the power pole
mounted on the transom, if this option is installed.
Engine Trim and Tilt Switch
This switch is typically installed in the engine
control handle. It controls the trimming and
tilting of the engine. Refer to the Helm Control
Systems chapter and the engine owner’s manual
for information regarding the proper use of the
tilt and trim switch.
6.5 Additional DC Circuit Protection
Battery Switch Circuit Breakers
The battery switch circuit breakers are located
next to the battery switch in the battery switch
panel.
The “push to reset” circuit breakers are labeled
for the accessory circuit they protect. If a breaker
trips, the reset button pops out and can be felt
through the protective cover. Press the button
to reset the tripped breaker. If the breaker trips
again, find and correct the problem before reset -
ting the breaker.
Battery Switch Panel
Battery Selector Switch and Circuit Breakers
Release Well/Baitwell Switch Panel
Helm Main
Provides protection and electrical current to the
primary circuit for the helm accessory switch
panel. Other circuit breakers located near the
switches in the panel protect the individual cir-
cuits. This “push to reset” breaker is supplied
current when the battery switch is activated.
Electronics
Provides protection and electrical current to the
main electronics circuit for the helm. This “push
to reset” breaker is supplied current when the
battery switch is activated.
12V Recept
Provides protection and power for the 12 volt ac-
cessory plugs. This “push to reset” breaker is sup-
plied current when the battery switch is activated.