Display Cabinet Manual
Revised 11.10.17
6
1. After unit has been allowed to cool and has been unplugged, remove any excess
product remaining in the bottom.
2. Clean all surfaces with a non-abrasive food safe cleaner.
This appliance should not be cleaned with a water jet.
XI.
SERVICE INSTRUCTIONS
Only a qualified person should perform the following diagnostic checks, and, if
necessary, corresponding adjustments and repairs. Many of the following procedures
may present an electrical shock hazard and can cause serious injury or death.
Perform work only on de-energized circuits. Failure to do so may lead to electrical
shock resulting in personal injury or death.
A. Parts
When ordering parts, refer to the recommend spare parts list included with this manual
or wiring diagram. Always supply the serial number and model number of the unit.
B. Check Unit Periodically
Periodically check electrical switch and cord for signs of wear. Check all screws and rivets
for tightness.
C. To Access Electrical Components
To access all electrical components, unplug power cord from outlet, and then lay unit on its
side and remove the four screws from the bottom cover, exposing heating element, switch,
and wiring.
THIS UNIT IS NOT FUSED.
D. Troubleshooting
PROBLEM
POSSIBLE CAUSE
ACTION
Unit will not heat.
Unit unplugged or not switched
on.
Plug unit in. Turn on power.
Loose connection to heater.
Repair connection.
Light will not work.
Unit unplugged or not switched
on.
Plug unit in. Turn on power.
Bulb burned out.
Replace bulb with
recommended replacement
part (#EP2053-220)
RECOMMEND SPARE PARTS LIST
PART DESCRIPTION
PART NUMBER
