Display Cabinet Manual
Revised 11.10.17
5
Connect the unit only to the correct power source.
Make certain the main power switch on the cabinet is in the 'OFF' position when
plugging into power source.
3.
Install the racks
Install the clips in all four corners at the same height, as desired. The unit is provided with
two (2) racks and eight (8) clips which can be installed to accommodate different size
packaging.
IX.
OPERATING INSTRUCTIONS
Do not attempt to operate the unit until you have read and understood this manual.
Failure to do so may result in serious injury or death.
Do not attempt to operate your unit unless the installation instructions have been strictly
adhered to. Failure to do so may result in serious injury or death.
Operate the unit only if it is in sanitary condition (SANITATION INSTRUCTIONS).
Failure to do so may result in illness to your customers.
1.
Turn on rocker switch to turn on light and heat pad.
2.
With racks already installed at desired height, load unit with product. Do not overfill the
cabinet.
3. Dispense product through the front door. Door can be installed on opposite side to open
opposite direction.
X.
SANITATION INSTRUCTIONS
Be certain the unit is turned off and the power is unplugged before sanitizing, unless a
specific cleaning procedure requires power to the machine. Failure to do so could
result in serious injury or death.
Do not clean heated surfaces until they have been given sufficient time to cool.
Failure to do so may result in serious burns or scalds.
Do not immerse the unit in water. This will damage the electrical components, and may
cause short circuits, resulting in an electrical shock hazard if power is applied.
