Wire the Zūm J-Box Device
NOTES:
l
Only knock out the opening intended for use in the installation.
l
Partially knocking out any opening will cause the box to no longer be
Chicago Plenum rated.
1. Connect Chicago plenum rated fixture whip or metal conduit to the
Class 1 side of the enclosure. To facilitate wiring, five push-back style,
air-tight knockouts are provided on the Class 1 side of the enclosure;
two 3/4 in. knockouts and three 1/2 in. knockouts.
2. Wire the Zūm J-Box device as described in its Quick Start that is
located at
. The illustration that follows is
for reference only.
NOTE:
If necessary, make Class 2 connections between the Zūm
J-Box device and other low-voltage devices. To facilitate wiring, ten
push-back style, air-tight knockouts are provided on the Class 2 side
of the enclosure; six 3/4 in. knockouts and four 1/2 in. knockouts.
3. Connect the ground wire to the ground tab on the divider in the
enclosure.
NOTE:
The electrical box as well as the equipment installed in the box
must be grounded using the included #8 grounding lock washer,
#8-32, 3/8 in. grounding screw, and 18 AWG (minimum) wire that has
been terminated with an appropriate ring terminal.
Wire the Zūm J-Box Device - Example
3
ZUMMESH-JBOX-FMKT-CP
Quick Start
Chicago Plenum Enclosure for Zūm® Wireless J-Box Devices
