Docking Station for WPR-48
Crestron
WPR-DS
Indicators
(Power)
Illuminates green when 12 VDC power is provided to the WPR-DS via the external
power pack.
CHG (Charge)
Illuminates (red) when a WPR-48 is inserted in the WPR-DS cavity and their
contacts meet. The LED remains ON while the rechargeable battery is charging.
Recharge of the WPR-48 battery takes up to 1.5 hours. As long as the contacts of the
WPR-48 and the WPR-DS remain together, the WPR-DS “trickle charges” the
WPR-48 in an attempt to maintain the handheld remote at full charge for optimum
performance. The duration of a “trickle charge” is continuous as long as the WPR-48
is not fully charged.
RDY (Ready)
Illuminates (red) when the WPR-48 in the charging cavity is fully charged.
Industry Compliance
As of the date of manufacture, this unit has been tested and found to comply with
specifications for CE marking and standards per EMC and Radiocommunications
Compliance Labelling (N11785)
NOTE:
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that
may cause undesired operation.
Setup
Power Source
CAUTION:
Use only Crestron power supplies for Crestron equipment. Failure to
do so could cause equipment damage or void the Crestron warranty.
The DC power socket connector on the rear of the unit is used to supply power via
the PW-1205 (110V USA and Canada) or PWI-1210 (230V International) external
power pack supplied with the docking station.
4
•
Docking Station for WPR-48: WPR-DS
Operations Guide – DOC. 6255A
