G-Series Touchpanel Interface
Crestron Isys
®
TPS-G-TPI
To configure the unit, it may be necessary to access a series of setup screens prior to
viewing run-time screens that are loaded into the interface for normal operation. The
MAIN MENU for configuring the interface appears when a finger is held to the
connected touchscreen as power is applied, or after the hardware reset button is
pressed and released. Remove your finger when the message "SETUP MODE"
briefly appears on the touchscreen.
Upon entering SETUP MODE, the MAIN MENU, as shown in the following
illustration, displays four buttons:
Touch Screen Calibration
,
Exit and Run
Program
,
Setup
, and
Diagnostics
.
The
Exit and Run Program
button verifies that all of the setup information has
been saved to the EEPROM and displays the main page that has been programmed
into your system. The remaining buttons on the MAIN MENU open other menus,
which are discussed in subsequent paragraphs.
MAIN MENU
¥
Isys
®
G-Series Touchpanel Interface: TPS-G-TPI
Operations Guide – DOC. 6445
14
