Crestron
TPMC-3X-DSW
Wall Mount Docking Station for TPMC-3X
Setup
Installation
To prevent overheating, do not operate this product in an area that
exceeds the environmental temperature range listed in the table of
specifications.
The following tools and accessories are required for installation of a
TPMC-3X-DSW:
•
Standard 1-gang electrical box (not supplied)
•
Flat head screwdriver (not supplied)
•
Two #06-32 x 1” screws (included)
After Cresnet power (or other Crestron 24 Volt power source) wiring has
been installed and verified, use the following procedure to install the
TPMC-3X-DSW.
1. Turn system power
OFF
.
2. Connect the power supply cable to the
24
and
G
pins on the
TPMC-3X-DSW’s
PWR
connector.
3. Attach the TPMC-3X-DSW to the electrical box using the two
supplied #06-32 x 1” screws (2013235).
CAUTION:
Excess wire that is pinched between the TPMC-3X-DSW
and the electrical box could short out. Make sure all excess wire is
completely inside the electrical box and not between the box and the
TPMC-3X-DSW.
4. Attach the faceplate using the screws that came with the faceplate.
5. Turn system power
ON
.
Operations & Installation Guide – DOC. 6816B
Docking Station: TPMC-3X-DSW
•
5
