FlipTop Data Center
Crestron
QM-FTDC
NOTE:
This procedure sets the Net ID for the QM-FTDC in the program only.
It does not automatically set the Net ID for the QM-FTDC itself. SIMPL
Windows automatically changes Net ID values of a device added to a program if
a duplicate device or a device with the same Net ID already exists in the
program. Always ensure that the hardware and software settings of the Net ID
match. For Net ID hardware setting details, refer to “Identity Code” on page 15.
Symbols in Programming Manager
Three symbols make up the QM-FTDC: Basic Controls, Microphone Controls,
and Buttons. These symbols may be opened in
Detail View
. Following each
symbol, a table lists the symbol input and output signals, respectively, and their
functional description.
Basic Controls
The Basic Controls module is built into slot 01 of the QM-FTDC.
•
The QM-FTDC provides one RGB video input labeled COMPUTER,
which accepts one computer or component video source.
•
The QM-FTDC provides one stereo line-level input labeled
COMPUTER AUDIO.
•
In addition to the stereo audio, the QM-FTDC provides two
microphone/line-level inputs.
•
The QM-FTDC provides one QM output that transmits the RGB or
component video together with the program audio and one or both
microphones via CresCAT-QM.
QM-FTDC Symbol – Detail View of Basic Controls
NOTE:
Use an Analog Initialize to send a decimal input signal to the symbol.
QM-FTDC Basic Controls – Signal Descriptions
SIGNAL TYPE
AND NAME
DESCRIPTION
Digital output:
<
RGB Detect
>
Indicates that TTL H-sync is detected on the COMPUTER
input. The feedback remains high for as long as video is
detected.
High/1 = Computer video detected; Low/0 = No video detected
Digital output:
<
YPbPr Detect
>
Indicates that G/Y-sync is detected on the COMPUTER input.
The feedback remains high for as long as video is detected.
High/1 = Component video detected;
Low/0 = No video detected
Continued on the following page
34
•
FlipTop Data Center: QM-FTDC
Operations & Installation Guide - DOC. 6312A