Crestron
PAC2M
Professional Automation Mini Computer
installation in a double-wide CAEN. Complete the procedure below to attach the
PAC2M to the CAEN. A #2 Phillips screwdriver is required.
1. Using a #2 Phillips screwdriver attach the four supplied self-tapping
pan Phillips screws (8B x ¼” length) by screwing them in partially, to
allow room to mount the PAC2M (refer to illustration that follows).
2. Mount the PAC2M on the CAEN (where you attached the screws),
slide the unit to the right to ensure the screws fully engage the slots in
the flanges and tighten the screws.
NOTE:
For a single-wide CAEN, attach screws on right (screw them in partially),
mount the PAC2M where you attached screws, attach screws on left and fully tighten
all screws.
Mounting the PAC2M in the CAEN
Double-wide
CAEN
CLX-Series Module
8B ¼" screw
PAC2M
Power Supply
The PAC2M can be powered through the 2-pin
PWR
connector or by an external
power pack (such as the PW-2420RU) but not by both. Using the
PW-2420RU, the PAC2M may provide power to peripheral Cresnet devices (via the
built-in Cresnet Hub/Repeater) up to a total of 45 Watts. If additional power is
needed, Crestron recommends its CNPWS-75 (75 watt) External Power Supply.
Operations Guide – DOC. 6507
Professional Automation Mini Computer: PAC2M
•
11
