Crestron
MPS-250
Multimedia Presentation System 250
NOTE:
This function will only work if a CLS-C6, infiNET switch, or infiNET
dimmer was previously identified and connected to the MPS-250. The CLS-C6 can
be identified as a Cresnet device in the MPS-250 setup screens as described on page
66. Crestron’s infiNET switches and dimmers require a C2N-MNETGW to be
identified as described on page 66 in addition to identifying the individual switch
and/or dimmer with a unique identity code (MNET ID) using Crestron Toolbox.
CLW-DIM1RF and CLW-DIMS1RF dimmers use MNET IDs 03 and 04 while
CLW-SW1RF and CLW-SWS1RF switches use MNET IDs 05 and 06. For
information on identifying infiNET switches and dimmers, refer to the Crestron
Toolbox help file.
Raise or Lower Drapes
To raise or lower the drapes:
1.
Press the soft button labeled
Environ
.
2.
Press the soft button labeled
Drapes
.
3.
To raise the drapes, press the soft button labeled
Up
. To lower the drapes,
press the soft button labeled
Down
. The display will indicate the status of
the drapes.
NOTE:
This function will only work if a drape controller has been configured in
Crestron SystemBuilder or SIMPL Windows and connected to the MPS-250.
Control from a Keypad
The following describes operation of the system when using the out-of-the-box
functionality and either a C2N-DB12 or CNX-B12 keypad. If a custom program has
been created, the MPS-250 may function differently.
NOTE:
Buttons for the keypad are custom engraved using Crestron SystemBuilder
software. For instructions on installing the buttons on the keypad, refer to the
keypad’s guide.
The keypad has twelve buttons as shown in the following diagram.
C2N-DB12 Buttons
BNC 1
BNC 2
RGBHV 4
QM IN 6
NOT USED
NOT USED
POWER
RGBHV 3
RGBHV 5
MUTE
VOL UP
VOL DOWN
NOTE:
Custom buttons can be created using Crestron Engraver software. For
instructions on installing the custom buttons, refer to the keypad guide.
Operations Guide – DOC. 6647A
Multimedia Presentation System 250: MPS-250
•
79
