Mud Mount Kits
Crestron
MMK-1000L & WMKM-1000L
drywall. Verify that the fastener plates are between the mounting plate
and the drywall.
9. When the fastener/mounting plate assembly is in position, bend the top
two flanges of the mud ring upward (approximately 90 degrees) and the
bottom two flanges downward (approximately 90 degrees). Refer to the
illustration after this step.
NOTE:
Fastener/mounting plate assembly will have slight play; this is normal. It
allows for minor adjustments to the touchpanel during installation.
Bend Flanges
APPROX. 90°
TABS UP
BEND THESE
APPROX. 90°
TABS DOWN
BEND THESE
10. Use four standard drywall screws (of adequate length) to secure the
plate to the fastener/mounting plate assembly. The screws pass through
the tapped holes in the mounting plate and are secured to the extruded
holes of the fastener plates.
11. Verify that the plate is level before tightening.
NOTE:
Do not over tighten screws. Doing so may over-dimple or rip the plate.
12. Use a #2 Phillips screwdriver and tighten the drywall screws by hand
so that they slightly dimple into the holes in the mud ring plate.
6
•
Mud Mount Kits: MMK-1000L & WMKM-1000L
Installation Guide – DOC. 6062
