Crestron
MMK-1000L & WMKM-1000L
Mud Mount Kits
2. Slide a push-on fastener over each pin on the top fastener plate. Do not
push the fasteners all the way down onto the pins. Slide them on
enough to keep the fastener plate and mounting plate as one
fastener/mounting plate assembly. This allows for minor mounting
adjustments.
3. Use the second fastener plate and repeat steps 1 and 2 on the lower part
of the mounting plate.
4. Locate an area on the wall that is free of miscellaneous wiring and
studs.
5. Make a small hole near the middle of the designated site; verify that the
location is suitable.
NOTE:
Make the cutout as level as possible. The mounting plate allows for only
minor leveling adjustments.
6. Use the drywall saw or equivalent to produce a level, square cutout in
the drywall that measures 4½ inches wide (114 mm) x 4½ inches high
(114 mm).
7. Insert the symmetrical mud ring plate into the opening, as shown in the
illustration after this step.
Insert the Mud Ring Plate into the Opening
MUD RING
DRYWALL CUTOUT:
4
1
2
in WIDE x 4
1
2
in HIGH
(114 mm WIDE x 114 mm HIGH)
8. Carefully pass the fastener/mounting plate assembly through the
opening and rest the assembly against the interior surface of the
Installation Guide – DOC. 6062
Mud Mount Kits: MMK-1000L & WMKM-1000L
•
5
