Crestron
TPMC-8T
Isys i/O™ 8.4” TableTop WiFi Touchpanel
Touch
Refresh network list
to scan for available access points.
The TPMC-8T is already configured for DHCP. To establish static processing or to
switch between DHCP and static IP, use the
General
tab of the “Wireless Network
Connection Properties” window (refer to picture on page 37), select
Internet
Protocol (TCP/IP)
and touch
Properties
.
Touch
Set up a wireless network for a home or small office
to start the
Wireless
Network Setup Wizard
.
The
Wireless Network Setup Wizard
will create a network with the
Network
Authentication
value set to
Open
. If your Wireless Access Point is configured with a
value other than
Open
, you must set this value manually, using the
Wireless
Networks
tab of the “Wireless Network Connection Properties” window (refer to
picture on page 38).
To manually configure your Wireless Access Point, perform the following
procedure:
1. In
the
Preferred Networks
section of the window, select your network and
touch
Properties
to open the “Properties” window for your network.
“Network (your network name) Properties” Window
2. With
Data encryption
set to
WEP
, select
Open
from the
Network
Authentication
dropdown list.
3. Enter and confirm the
Network key
.
4. Touch
OK
.
Operations Guide – DOC. 6567C
Isys i/O™ 8.4” TableTop WiFi Touchpanel: TPMC-8T
•
39