infiNET™ SWITCHES
For detailed operating instructions, refer to the latest
revision of the infiNET Switches Operations Guide (Doc.
6397) which is available from the Crestron website.
Testing
Testing a -SLVS1RF
NOTE:
The device may be warm to the touch during
operation. This is normal.
Tap the top of the button to turn on the load. Tap the
bottom of the button to turn off the load. It will emulate
the RUN mode of the -SWS1RF (even if connected to a
-SWS4RF) unless the mode selection switch of the master
is set to “OFF”. For more information, refer to the latest
version of the infiNET Switches Operations Guide (Doc.
6397) which is available from the Crestron website.
Test the installation by setting the switch’s mode selection
switch (shown in the following diagrams) to the “RUN”
position and perform either of the following steps
(depending on the switch model).
Parts of CLW-SW1RF, -SWS1RF
Button
Mode Selection Switch
RUN
SET
OFF
Parts of CLW-SW4RF, -SWS4RF
Button 2
Mode Selection Switch
Button 4
Button 3
Button 1
RUN
SET
OFF
Testing a -SW1RF and -SWS1RF
With the mode selection switch in the “RUN” position,
tap the top of the button to turn on the load. Tap the
bottom of the button to turn off the load.
For detailed operating instructions, refer to the latest
revision of the infiNET Switches Operations Guide (Doc.
6397) which is available from the Crestron website.
Testing a -SW4RF and -SWS4RF
With the mode selection switch in the “RUN” position,
tap the Button 1 to turn on the load. Tap Button 1 again to
turn off the load.
6
•
infiNET™ Wall Box Switch : CLW-SW1/4RF, SWS1/4RF, & SLVS1RF
Installation Guide - DOC. 6293A
