iMedia Table Mount Computer Center
Crestron
IM-TCC
Cutout Diagram
1. Position the IM-TCC in the mounting hole or in the underside location.
2. Install the left and right brackets using the cover screws provided.
(Note that steps 1 and 2 should be reversed for an underside location
installation.)
3. For cutout mounting, install the supplied #6-32 screws and tighten the
screws equally until they contact the backside of the mounting surface.
For underside location mounting, use four #6 hardware (not supplied)
to secure the unit to the underside of the surface.
NOTE:
Do not over-tighten the screws as this may damage the surface and/or
the unit.
Cutaway View of Cutout Mounting
Hardware Hookup
Refer to the following hookup diagram and, aside from attaching power last,
complete the connections in any order.
NOTE:
To prevent overheating, do not operate this product in an area that
exceeds the environmental temperature range listed in the specifications table.
Consideration must be given if installed in a closed or multi-unit rack assembly,
inside a closed desk, or in a closed podium since the operating ambient
temperature of these environments may be greater than the room ambient.
Contact with thermal insulating materials should be avoided on all sides of the
unit.
NOTE:
The maximum continuous current from equipment under any external
load conditions shall not exceed a current limit that is suitable for the minimum
wire gauge used in interconnecting cables. The ratings on the connecting unit's
supply input should be considered to prevent overloading the wiring.
8
•
iMedia Table Mount Computer Center: IM-TCC
Operations & Installation Guide - DOC. 6383
