Crestron
CLS-C6/C6M & CLSI-C6/C6M
iLux Integrated Lighting System
Operations Guide – DOC. 6347E
iLux Integrated Lighting System: CLS-C6/C6M & CLSI-C6/C6M
•
17
When the button is released, the LED for that button should flash once
to indicate that programming took place.
2.
Next, use the up/down button to scroll to the next function and value to
be assigned, and assign the desired buttons. Repeat this procedure for
each function and value to be assigned.
3.
After assigning all button functions, press
Save
, and the button function
information is saved. If
Cancel
is pressed, or exit by some other
mechanism (e.g., timeout), the state returns to what it was before
Setup
mode was entered.
NOTE:
The
ON
and
OFF
buttons on the CLS-C6 cannot be
programmed. The operation of the up/down button is programmed
using the “ud” setup function.
•
If an illegal button is programmed (e.g., the
ON
button, or program a
remote keypad button as master raise/lower-up/down), LED flashs on three
times to indicate that setting did not take place, and the two-digit display
shows “Er.”
NOTE:
Other button functions, including “shifted” functions, can be
defined using the iLux Designer configuration program.
Setup Up/Down Button Function (ud)
To define operation of the up/down button, enter
Setup
mode and scroll to the “ud”
option (using the
^
and
v
buttons).
•
Use the up/down button to select the desired mode. The display flips
between “ud.” and “#”, where # is the mode, as defined in the following
table.
FUNCTION
MODE
Lights (Last Scene) Master Up/Down
L
Shades Master Up/Down
S
•
The first function to be displayed is the current function. Since there are
other functions that can be programmed via the iLux Designer, if the current
function is not one of these, the display should show “ud.—”. Pressing the
up/down button then goes to mode L.
•
Press
Save
to save the new setting or
Cancel
to retain the original setting.
Setup Occupancy Sensing (oc)
To define operation of the Occupancy Sensing feature, enter
Setup
mode and scroll
to the “oc” option (using the
^
and
v
buttons).
•
Use the up/down button to select the desired mode. The display alternates
between “oc.” and the mode number, as defined in the following table.
MODE
CODE
Do nothing on either exit or entry
0
Recall specified scene on exit, do nothing on entry
1
Recall specified scene on entry, do nothing on exit
2
Recall specified scenes on entry and exit
3