NOTES:
Observe the following points.
l
Codes: This product should be installed and used in accordance with
appropriate electrical codes and regulations.
l
If you are unsure about any part of these instructions, consult a
qualified electrician.
l
Wiring: Use copper wire only. For supply connections, use wires
rated for at least 75° C (167° F).
l
Temperature: For use where temperatures are between 32° to 86° F
(0° to 30° C).
l
Electrical Boxes: Devices mount in standard electrical boxes. For
easy installation, use 3-1/2 in. (89 mm) deep electrical boxes. Several
devices can be installed in one electrical box (multigang). For a
smooth appearance, one-piece multigang faceplates (not supplied)
must be installed. When installing into a multigang box, do not fully
tighten the devices to the box until the faceplate has been aligned.
l
When installing into a multigang box, do not fully tighten devices to
box until faceplate has been aligned.
l
Switches: Mechanical 3- or 4-way switches do not work with .
l
Spacing: If mounting one device above another, leave at least 4-1/2
in. (115 mm) vertical space between them.
Installation
WARNING:
Turn off power at the circuit breaker. Installing with power
on can result in serious personal injury and damage to the device.
Install the HZ-AUX:
1. Turn power off at the circuit breaker.
WARNING:
If the HZ-AUX is used in a multiway configuration,
power may need to be turned off at multiple breakers.
2. Wire the device as shown in
, where typical wiring
configurations for the HZ-AUX are shown. Select the appropriate
configuration and connect the necessary wires. In multigang
installations, daisy-chain Hot and Neutral wires with other Horizon
devices to eliminate excess wiring.
3. Fold the wires into the electrical box. Avoid pinched wires.
4. Secure the HZ-AUX to the electrical box using the integrated mounting
screws on the device. To allow for adjustments, do not fully tighten the
screws at this time. Ensure that any text on the device is in the proper
orientation and facing up.
CAUTION:
Do not overtighten the screws when attaching the
keypad to the electrical box. Damage to the unit and undesired
functionality may occur.
5. Place the metal mounting bracket (not supplied) over the back of the
HZ-AUX. The two parts of the metal mounting bracket clip together
which allows the wiring to remain in place.
NOTE:
When installing the HZ-FP-G faceplate over an old work
electrical box, do not use the metal mounting bracket.
6. Attach the HZ-FP-G series faceplate using the faceplate mounting
screws. Ensure that the "Top" label is properly oriented.
7. Ensure that the HZ-AUX is properly aligned within the HZ-FP-G and
then fully tighten the integrated mounting screws to secure the device
to the electrical box.
8. Attached the magnetic top and bottom trim pieces to the HZ-FP-G.
9. Ensure that all buttons actuate without sticking.
10. Restore power at the circuit breaker.
2
HZ-AUX
Quick Start
Horizon™ In-Wall, Multiway Remote