Crestron
HBK-3000 & SMK-3000
Hatch Back & Swivel Mount Kits
HBK-3000 Assembly View
SMK-3000 Assembly/Installation Procedure
To attach the SMK-3000 Swivel Mount Kit to the TPS-3000 Touchpanel
and install the assembly on a suitable mounting surface, refer to the
following procedures and the illustration on page 5.
1. Prepare the mounting surface using the template provided with the
kit. The center hole for the swivel assembly should be 2.5-inches
minimum; 2.6-inches maximum. Position the template so that the
edge indicated as ‘front’ aligns with desired front position of the
touchpanel. Observe the dashed line indic
a
ting front edge of the
touchpanel base to ensure the touchpanel will not overhang the
mounting surface.
2. If necessary, to prevent errors when reconnecting, label and
disconnect any cables connected to the touchpanel.
3. Place the touchpanel face down on a padded surface to prevent
damage to the display screen. Adjust tilt angle if needed. Avoid
putting pressure on the display housing.
4. Refer to the assembly view for the HBK-3000 Hatchback Kit
above and remove the two screws
A
from the rear of the
touchpanel that correspond to the Mounting Holes in the Metal
Bracket.
Installation Guide – DOC. 6110
Hatchback & Swivel Mount Kits: HBK-3000 & SMK-3000
•
3
