CRESTRON GREEN LIGHT™
Power Switching
Connector Wiring
RED
WHI
T
E
BLUE
BLACK
NET:
TO CONTROL SYSTEM AND
OTHER CRESNET DEVICES
POWER:
24 VDC JUMPERED FROM NET
PORT or EXTERNAL SUPPLY.
PROVIDES CRESNET POWER
TO THE MODULES
OVERRIDE:
FROM DEVICE PROVIDING
CONTACT CLOSURE & TO
OTHER DEVICES RECEIVING
OVERRIDE SIGNAL
NET Port Wiring
When wiring the supplied
NET
connectors for connection to a Crestron control system or other device on the
Cresnet network, use Crestron certified wire such as CRESNET-NP or CRESNET-P.
To ensure optimum performance over the full range of your installation topology, use Crestron certified wire.
Failure to do so may incur additional charges if support is required to identify performance deficiencies because
of using improper wire.
When daisy-chaining connections between
NET
ports, strip the ends of the wires carefully to avoid nicking the
conductors. Twist together the ends of the wires that share a pin on the network connector, insert the connection
into the Cresnet connector, and tighten the retaining screw. Repeat the procedure for the other three conductors.
POWER Port Wiring
Low voltage (24 VDC) power must be supplied to the modules either internally via devices connected to the
NET
port or externally via a Cresnet power supply connected to the
POWER
port.
To power the modules internally from line power, install a jumper from the
INT
pin on the supplied
POWER
connector to the
EXT
pin on the
POWER
connector as shown in the following diagram.
Providing Cresnet Power Internally
When a lighting module is powered from line power, the module’s
PWR
LED will illuminate.
Installation Guide – DOC. 6672B
CRESTRON GREEN LIGHT Power Switching
•
9