Crestron GLXP-DIMFLV8, Installation Manual, Page: 14 / 16

Power Switching CRESTRON GREEN LIGHT™
Appendix A: Setting Module Net IDs
The following procedure will normally be performed by an authorized Crestron representative as part of the System
Commissioning phase. For system wiring and basic testing as described on pages 5 and 11, it is not necessary to
perform this step. Only perform this step if instructed by an authorized Crestron representative, or when replacing
modules on a system that have already been commissioned (in the latter case the Net ID should be set to match the
Net ID of the module being replaced).
The Net ID of each module in the cabinet can be changed from the front panel of each module. The Net IDs of each
module in the system must be unique.
To set the Net ID using the front panel:
1. Press the recessed SETUP button to enter the Setup mode. The SETUP LED illuminates.
2. As shown in the following diagram, press the left button under the NET ID display to change the left digit
of the Net ID or press the right button under the NET ID display to change the right digit of the Net ID
number.
Changing the Net ID
3. When the desired Net ID is displayed, press the SETUP button to exit the Setup mode. The SETUP LED
extinguishes.
If the
SETUP button is not pressed, the Setup mode will time out after one minute activity and the Net ID
will revert back to its original value.
14
•
CRESTRON GREEN LIGHT Power Switching Installation Guide – DOC. 6672B