Crestron CNWM, Operation Manual

Page: 8 / 32

CRESTRON
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. The equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
As of the date of manufacture, the unit has been tested and found to comply with
specifications for CE marking.
Setup
General Use and Safety
DANGER: The CNWML contains a Class IIIa laser. Avoid direct eye exposure.
Compliance to the following suggestions may extend the life of the wireless mouse
and laser.
•
If the unit is not going to be used for a month or longer, remove
batteries. Never leave weak or dead batteries in the unit; they might
leak chemicals that can damage the unit.
•
Use care when handling the unit. Dropping the unit can unfocus the
lens, damage circuit boards, and cause the unit to work improperly.
•
Operate and store the unit in moderate temperatures. Do not place the
unit in environments below freezing or exceeding 110
°
F. Temperature
extremes can shorten the life of electrical devices, damage the batteries,
and distort or melt plastic parts.
•
Keep the unit away from dust and dirt that can cause premature wear
on parts. Use a damp cloth to wipe the unit. Do not use harsh
chemicals, cleaning solvents, or strong detergents to clean the device.
RF Identity Code
Every hand-held wireless transmitter communicating with either the SmartPresenter,
ST-CP or CNRFGWA requires a unique RF identity (ID) code. The code is a two-
4
•
Wireless Mouse Operations Guide - DOC. 5700A