CLW-DIM, DIMS, & SLVD(W/A/B)
Physical Description
Physical view of CLW-SLVD (clockwise from top; Top, Side,
and Front)
The -DIM and -DIMS contain three buttons (one large,
two small), a light emitting diode (LED), and a three-
position slider-switch, shown after this paragraph. The
-SLVD is similar to the -DIM and -DIMS but does not
have the slider-switch. Line voltage connections are made
at the rear of the dimmer. Three Class 2 low voltage
wires, located on the front of the switch provide a Cresnet
connection to a control system. The wires are routed to
the bottom of the unit for placement outside of the wall
box.
CLW-DIM/DIMS (L) and CLW-SLVD (R) shown in white
The -DIM, -DIMS, and -SLVD mount in a standard
wallbox and are covered using a decorative faceplate (not
included).
Physical view of CLW-DIM/ DIMS (clockwise from top; Top,
Side, and Front)
Industry Compliance
This product is Listed to applicable UL Standards and
requirements by Underwriters Laboratories Inc.
Important Notes
Read before installation.
•
Codes: Install in accordance with all local and
national electrical codes.
Alternate wiring methods may be used for the
Class 2 wiring connection. The 2002 National
Electrical Code (Article 725-55) prohibits Class
2 conductors of the -DIM, -DIMS, and -SLVD to
occupy the same outlet box as the power
conductors. The exception is Part D of Section
725.55 of the 2002 National Electrical Code,
which allows a device’s power conductors to be
installed near (0.25 inch minimum spacing)
associated Class 2 conductors in the same outlet
box. Consult the 2002 National Electrical Code
Handbook and your local electrical inspector
before proceeding.
Do not use the supplied butt-splice connectors if
the Class 2 conductors are to be installed in the
wallbox with the power conductors. Use
2
•
Stand Alone Wall Box Dimmer : CLW-DIM, DIMS, & SLVD
Installation Guide – DOC. 5995B
