iLux Universal Dimmer Expansion Module
Crestron
CLS-EXP-DIMU
Setup
Important Notes
Read before installation.
Use copper conductors only – rated 75°C or greater.
Installation
The CLS-EXP-DIMU can be installed vertically on a wall
and it can also be installed in a space used for
environmental air as defined in NEC
®
Article 300.22(C).
Refer to the following diagram when installing a
CLS-EXP-DIMU module.
Module Installation
Adhere to the following instructions to ensure proper
ventilation:
•
Install the device vertically on a vertical surface.
NOTE
: To prevent potential heat damage to
drywall, do not mount the CLS-EXP-DIMU
directly onto drywall. Mount a 1/2 in (13 mm)
piece thick (minimum) plywood between the
CLS-EXP-DIMU and the drywall.
•
Install the device with 6 in (152 mm) of
clearance from the top and bottom of the device.
Hardware Hookup
WARNING: RISK OF SERIOUS PERSONAL
INJURY.
Turn off power at the circuit breaker(s) prior to
installation. Installing with the power on can result in
serious personal injury and damage to the device.
1.
Use a #2 Phillips screwdriver to remove the
cover screws, as shown in the following
diagram, and remove the cover.
Remove Cover Screws
2.
Depending on the module’s application, select
the appropriate configuration from one of the
wiring diagrams on the next page and connect
the CLS-C6 and load(s) as shown.
•
Do not connect wires of differing gauge to a
single terminal.
•
Strip wires to 7/16 in (11 mm).
•
Tighten terminal screws to 7 in-lbs
(0.79 Nm).
NOTE
: Dimmers controlling one or more
CLS-EXP-DIMU modules must not be wired to
control any other type of load.
NOTE
: While these diagrams show a CLS-C6
as the controlling source, other Crestron products
such as CLW-Series wall dimmers (Cresnet
®
and
infiNET™), DIN-Series, and CLX-Series
dimming modules can be used as well. Refer to
the specific dimmer’s installation guide for
detailed information.
NOTE
: When using a CLW-Series wall
dimmer, the wall dimmer must be wired with a
dedicated neutral wire.
Cover Screws
(x4)
CLS-EXP-DIMU Module
Mounting Screw,
Qty 4 (Not
Supplied)
Mounting Surface
6
•
iLux Universal Dimmer Expansion Module: CLS-EXP-DIMU
Installation Guide – DOC. 6682E
