background image

As of the date of manufacture, the device has been tested and found to comply with specifications for 
CE marking.

Federal Communications Commission (FCC) Compliance Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following 
conditions:(1) This device may not cause harmful interference and (2) this device must accept any 
interference received, including interference that may cause undesired operation.
CAUTION:  Changes or modifications not expressly approved by the manufacturer responsible for 
compliance could void the user’s authority to operate the equipment.
NOTE:  This equipment has been tested and found to comply with the limits for a Class B digital 
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable 
protection against harmful interference in a residential installation. This equipment generates, uses 
and can radiate radio frequency energy and, if not installed and used in accordance with the 
instructions, may cause harmful interference to radio communications. However, there is no guarantee 
that interference will not occur in a particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be determined by turning the equipment off 
and on, the user is encouraged to try to correct the interference by one or more of the following 
measures:
 

•  Reorient or relocate the receiving antenna.

 

•  Increase the separation between the equipment and receiver.

 

•  Connect the equipment into an outlet on a circuit different from that to which the receiver is 

connected.

 

•  Consult the dealer or an experienced radio/TV technician for help.

Industry Canada (IC) Compliance Statement

CAN ICES-3(B)/NMB-3(B)

The CEN-C-TX-F and CEN-C-RX-F are Class 1 laser products that comply with safety regulations of 
IEC-60825-1 and with FDA 21 CFR 1040.10 and FDA 21 CFR 1040.11.

WARNING

:  Visible and invisible laser radiation when open. Avoid direct exposure to beam.

NOTE

:  Plug the included dust cap into the optical transceivers when the fiber-optic cable is 

unplugged.

The product warranty can be found at www.crestron.com/warranty.
The specific patents that cover Crestron products are listed at patents.crestron.com.
Certain Crestron products contain open source software. For specific information, please visit 
www.crestron.com/opensource.
Crestron, the Crestron logo, and CresFiber are either trademarks or registered trademarks of Crestron 
Electronics, Inc. in the United States and/or other countries. Other trademarks, registered trademarks, 
and trade names may be used in this document to refer to either the entities claiming the marks and 
names or their products. Crestron disclaims any proprietary interest in the marks and names of others. 
Crestron is not responsible for errors in typography or photography.
This document was written by the Technical Publications department at Crestron.
©2017 Crestron Electronics, Inc.

Crestron Electronics, Inc. 

Installation Guide - DOC. 7913A

15 Volvo Drive   Rockleigh, NJ 07647 

(2048046)

Tel: 888.CRESTRON 

02.17

Fax: 201.767.7576  

Specifications subject to 

www.crestron.com 

change without notice.

Reviews: