Crestron
C2N-TAMWX
AM/Weather Band Tuner
C2N-TAMWX Ports
The interface connection to the FM Tuner or the TV/FM Tuner and the headphone
jack are located on the front panel; connections for external antennas are located on
the rear panel. Refer to the illustrations and descriptions, which follow.
C2N-TAMWX Front Panel
PWR
AM /W X TUN ER
COM
REMOTE
CRESTRON
AM
C 2 N - T A M W X
WX
SIG
VOL
TUNE
BAND
MODE
K
J
C2N-TAMWX Rear Panel
E L E C T R O N I C S I N C . , R O C K L E I G H , N J 0 7 6 4 7
CRESTRON
U SA
AM ANT
S G
WX ANT
REMOTE (RJ-45)
The RJ-45
REMOTE
port on the front of the unit provides noise free CAT5
interface (up to 500 feet of straight-thru cable) to the companion FM Tuner or
TV/FM Tuner. Wiring for the connector is shown in the following diagrams.
PIN #
SIGNAL
1 +24V
2
+24V
3 COM+
4
Audio+
5 Audio-
6
COM-
7 Ground
8
Ground
NOTE:
This connector is to be used only to provide interface to Crestron products
specifically designed to work with this unit. It cannot be used for connections to
Cresnet or Crestron audio distribution devices.
AM ANT
This 2-pin (
S
,
G
) terminal block connector is used to connect an optional external
long wire or dipole AM antenna.
WX ANT
This Type F coaxial connector is for an external high-gain TV antenna cable (not
supplied) or for a fabricated cable for reception of weather band stations.
(Headphone)
This mini-phone jack on the front panel of the AMWX Tuner permits the use of
headphones to monitor the audio signal during installation and locating of antennas
for best AM and weather band reception. The volume mode, selected by the MODE
Operations Guide - DOC. 6267
AM/Weather Band Tuner: C2N-TAMWX
•
5
