FlipTop Touchpanel Control Center
Crestron
C2N-FT-TPS4/TPS4-U
5. Turn the four #10 screws equally until they contact the underside of the
mounting surface.
NOTE:
Do not over-tighten the #10 screws as this may damage the surface and/or
the unit.
Mounting Bracket Installation
NOTE:
Be careful not to press any screen pushbuttons or hard keys while closing
the Flip Top, even though the screen is disabled when the Flip Top begins to close
and all pressed buttons are released.
Hardware Hookup
Refer to the following hookup diagram and, aside from attaching power last,
complete the connections in any order.
NOTE:
To prevent overheating, do not operate this product in an area that exceeds
the environmental temperature range listed in the specifications table. Consideration
must be given if installed in a closed or multi-unit rack assembly, inside a closed
desk, or in a closed podium since the operating ambient temperature of these
environments may be greater than the room ambient. Contact with thermal insulating
materials should be avoided on all sides of the unit.
14
•
FlipTop Touchpanel Control Center: C2N-FT-TPS4/TPS4-U
Operations & Installation Guide - DOC. 6398