Crestron
BB-6000
Back Box
Installation Guide - DOC. 5826
Back Box: BB-6000
••
3
Securing Metal Electrical Box to Stud
SCREW
HOLES
0.50 in
(1.27 cm)
STUD
4.
Use three #6 screws, not supplied, to secure metal electrical box to the
stud.
5.
Pull Cresnet wire through open knockout(s) in the metal electrical box.
NOTE:
Wait for gypsum board to be hung before continuing with remainder of
construction method installation.
6.
Fasten template, supplied, to mounting surface; cut out and remove the
traced shape.
7.
Drill four 5/16” holes as marked on template. Only drill through
gypsum board. Use caution and do not drill through metal bracket that
rests behind gypsum board. Refer to "Cutout Detail of Supplied
Template" on page 7 for an illustrative reference.
8.
Drill 12 holes marked “A” on template with #20 bit. Only drill through
gypsum board. Use caution and do not drill through metal bracket that
rests behind gypsum board. Refer to "Cutout Detail of Supplied
Template" on page 7 for an illustrative reference.
9.
Position one metal mounting plate along the top horizontal edge so that
it covers the two center holes marked “A”.
10.
Use two pan head screws (1” length), supplied, to loosely secure the
bracket and plate to the mounting surface.
11.
Position one metal mounting plate along the bottom horizontal edge so
that it covers the two center holes marked “A”.
12.
Use two pan head screws (1” length), supplied, to loosely secure the
bracket and plate to the mounting surface.
