background image

Control the Display

The ZUMMESH-KP10AMBATT has ON, VOLUME UP, VOLUME DOWN, and OFF buttons 
that control the display.

ON

: Turns the display on.

VOLUME UP

: Raises the volume.

VOLUME DOWN

: Lowers the volume.

OFF

: Turns the display off.

Replace the Battery

WARNING: 

Refer to the following warnings before changing the batteries.

•  Do not ingest batteries. Ingesting a battery poses a chemical burn hazard.
•  This product contains a coin cell battery. If a coin cell battery is swallowed, it 

can cause severe internal burns in just 2 hours and can lead to death.

•  Keep new and used batteries away from children. If the battery compartment 

does not close securely, stop using the product and keep it away from children.

•  If you think batteries have been swallowed or placed inside any part of the body, 

seek immediate medical attention.

CAUTION: 

The battery used in this device may present a risk of fire or chemical burn 

if mistreated. Do not recharge, disassemble, heat above 212 °F (100 °C), or incinerate. 
Replace batteries with an identical CR2032 only. Use of another battery may present a 
risk of fire or explosion.

To remove the battery, insert a pin or paper clip into the slot on the left side of the keypad. 
The battery slides out of the opposite side of the keypad.

To remove the battery, 
insert a pin or paper clip 
into the hole on the side.

NOTE: 

The battery must be inserted properly.

NOTE: 

The keypad will not operate if the battery is inserted incorrectly.

To install a new battery, insert the battery into the battery slot. The — terminal faces away 
from the wall.

Battery CR2032
(

) toward the front of the 

keypad

Additional Resources

Visit the product page on the Crestron website (

www.crestron.com

for additional information and the latest firmware updates. Use a QR 
reader application on your mobile device to scan the QR image.

This product is Listed to applicable UL

®

 Standards and requirements tested by Underwriters 

Laboratories Inc.
Ce produit est homologué selon les normes et les exigences UL applicables par Underwriters 
Laboratories Inc.

Federal Communications Commission (FCC) Compliance Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two 
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any 
interference received, including interference that may cause undesired operation.

CAUTION:

 Changes or modifications not expressly approved by the manufacturer responsible for 

compliance could void the user’s authority to operate the equipment.

NOTE:

 This equipment has been tested and found to comply with the limits for a Class A digital 

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable 
protection against harmful interference when the equipment is operated in a commercial environment. 
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used 
in accordance with the instruction manual, may cause harmful interference to radio communications. 
Operation of this equipment in a residential area is likely to cause harmful interference in which case 
the user will be required to correct the interference at his own expense.

Industry Canada (IC) Compliance Statement

CAN ICES-3(A)/NMB-3(A)

The product warranty can be found at 

www.crestron.com/warranty

.

The specific patents that cover Crestron products are listed at 

www.crestron.com/legal/patents

.

Certain Crestron products contain open source software. For specific information, please visit 

www.crestron.com/opensource

.

Crestron, the Crestron logo, and AirMedia are either trademarks or registered trademarks of Crestron 
Electronics, Inc. in the United States and/or other countries. UL and the UL logo are either trademarks 
or registered trademarks of Underwriters Laboratories, Inc. in the United States and/or other 
countries. Other trademarks, registered trademarks, and trade names may be used in this document 
to refer to either the entities claiming the marks and names or their products. Crestron disclaims 
any proprietary interest in the marks and names of others. Crestron is not responsible for errors in 
typography or photography.
This document was written by the Technical Publications department at Crestron.
©2018 Crestron Electronics, Inc.

Crestron Electronics, Inc. 

Installation Guide - DOC. 8332A

15 Volvo Drive, Rockleigh, NJ 07647 

(2052106)

Tel: 888.CRESTRON 

06.18

Fax: 201.767.7576  

Specifications subject to 

www.crestron.com 

change without notice.

Reviews: