23
AC POWER INLET:
This is the receptacle for an IEC line cord, which provides AC power to the unit. Connect the line cord to this connector to provide
power to the unit. Damage to the equipment may result if improper line voltage is used. (See line voltage marking on unit).
Never break off the ground pin on any equipment. It is provided for your safety. If the outlet used does not have a
ground pin, a suitable grounding adapter should be used and the third wire should be grounded properly. To prevent the
risk of shock or fire hazard, always make sure that the amplifier and all associated equipment is properly grounded.
NOTE: FOR U.K. ONLY
As the colors of the wires in the mains lead of this apparatus may not correspond with the colored markings identifying
the terminals in your plug, proceed as follows: (1) The wire which is colored green and yellow must be connected to
the terminal which is marked by the letter E, or by the Earth symbol, or colored green or green and yellow. (2) The wire
which is colored blue must be connected to the terminal which is marked with the letter N, or the color black. (3) The
wire which is colored brown must be connected to the terminal which is marked with the letter L, or the color red.
CROSSOVER MODE SWITCH
HIGH PASS
This position is used to activate the HIGH PASS filter for the corresponding channel. This Linkwitz -Riley filter will
limit the frequencies sent to the associated amplifier channel to those frequencies above 100 Hz. In situations where
separate subwoofer cabinets are being used, this position would indicate connecting the mid-high frequency speaker
cabinet to the channel associated with the HIGH PASS switch.
FULL RANGE
As the name implies, the Full Range position on this switch allows all frequencies to pass to the amplifier. Normally used
when connecting a full range speaker enclosure to the amplifier's output.
SUBWOOFER
This position is used to activate the LOW PASS filter for the corresponding channel. This Linkwitz-Riley filter will
limit the frequencies sent to the associated amplifier channel to those frequencies below 100 Hz. In situations where
separate subwoofer cabinets are being used, this position would indicate connecting the subwoofer speaker cabinet to
the channel associated with the Subwoofer switch.
CONNECTING INPUTS
Input connections are made via the 3-pin XLR (pin 2+) or 6.3 mm plug combination connectors on the rear panel of
the amplifier. The inputs are actively balanced. The input overload point is high enough to accept the maximum output
level of virtually any signal source.
CHANNEL MODE SWITCH
Allows switching between Parallel, bridge, and stereo modes.
CONNECTING OUTPUTS
All models have one combination 4 pole twist lock output connector per channel.
9
10
Rear Panel
12
11
13
9
13
10
10
11
11
12
Summary of Contents for Pro-LITE 2.0 / 3.0
Page 1: ...1 Pro LITE 2 0 3 0 Pro LITE 2 0 3 0 DSP Power Amplifers Owner s Manual ...
Page 37: ...37 Notes ...
Page 38: ...38 Notes ...
Page 39: ...39 Notes ...
