Step 3: Attach Display Plate
1. Using a second person for assistance, lay your TV face down on something soft so as not to scratch the TV screen.
2. Check the back of your TV to find the appropriate mounting pattern. If the mounting pattern is spaced more than 200mm x
200mm apart, you will need to attach the Display Plate Adaptors (Q) to the Display Plate (P). Use the M6 x 12mm (C) bolts,
M6 lock nuts (D) and S10 wrench (N) for this (see Figure 4).
3. Sort through the provided bolts until you find the correct size that easily fits into the back of your TV and fits snugly (the
bolt must turn at least 3 full turns. If you feel resistance stop immediately and select a smaller bolt.
The Crest Company is not responsible for any damage caused by screwing the bolt too far into the back of the TV.
Once you have selected the correct bolts (E to J), find the corresponding washers (K to L). If no bolts fit you will need to go
to your local hardware supplier to find the correct bolt and washer sizes.
4. Gently put the Display Plate on the back of the TV and align to the correct holes. Make sure it is oriented as shown (see
Fig. 5).
5. Using the correct bolt size and length, insert these through corresponding washers to attach the Display Plate to the rear
of the TV (see Figure 6). If one of the smaller bolts is selected then use the hole spacer (M) to fill out the Display Plate hole
and reduce its size for a snugger fit To avoid damaging TV, do not over tighten bolts.
Figure 3
A
B
A
A
A
A
A
Figure 2
Figure 4
Figure 5
Top
Bottom
Figure 6
Without spacers
With spacers
