Setup
In order to successfully use your
RTC2000
in just follow the simple steps outlined
below.
1. Make sure that your source device has the ability to correctly set the timing
needed by your display.
If this is not the case, do not use the RTC2200.
2. Connect the component output of your source to the component input of the
RTC2200
. Additionally, you can connect a RGBHV signal to the pass through
input of the
RTC2200,
which will be activated by the presence of a sync signal.
3. Connect
the
RTC2200
to your display using the VGA output connector.
4. Connect the power supply to the transcoder. Use only the supplied unit or an
exact equivalent.
Additional features
The
RTC2200
is shipped in full automatic mode with the following features:
•
The input is auto selected based on the presence of a sync signal on the RGB pass
through input. If sync is present on the RGB port that input is selected, otherwise
the component input is selected.
•
The color space is automatically selected based on the line frequency of the
incoming signal.
•
When shipped the gamma correction is adjusted to off. To increase low level
gamma, rotate the 25-turn potmeter on the back labeled BLK LVL clockwise.
Figure 1 below shows the response of the minimum and maximum gamma
setting. As can be seen, the amplitude of the video signal increases from
700mVpp at minimum gamma setting to about 800mVpp at maximum gamma
setting. After dialing in the gamma the contrast setting of the display may have to
be adjusted to compensate for this.
•
The horizontal and vertical sync width and position are automatically selected
based on the incoming signal.
•
The horizontal and vertical sync are set to negative polarity.
RTC2200 users manual v1.0
