Page 4 of 5
CI370X06R0
16.
To prepare the LED Driver Assembly enclosure, line up
the provided aluminum plate with the appropriate
mounting holes. See
Figure 12.
FIGURE 12
17.
Secure to the top of the housing with the provided screws.
See
Figure 13.
FIGURE 13
18.
Place the LED Driver Assembly over the nipple of the LED
Module Assembly as shown in
Figure 14.
FIGURE 14
19.
Secure using the supplied flat washer, beveled washer
and nut as shown in
Figure 15.
FIGURE 15
20.
See the
Electrical Connections
sections to wire the
luminaire.
21.
Connect the wire harness from the LED Module Assembly
and the LED Driver Assembly.
22.
Once electrical connections are made, lower the existing
driver enclosure over the installed LED Driver Assembly.
Using the key-hole slots secure the assembly and tighten
the existing screws. See
Figure 16.
FIGURE 16
23.
Attach the provided rubber ring over the edge of the glass
refractor.
24.
Carefully replace the globe over the Retrofit Assembly and
re-tighten the bolts that were loosened in Step 3.
25.
Reconnect power to the fixture.