2 of 3
CI380X01R5
ANGLE ADJUSTMENT
STEP 1:
After the luminaire is installed, the angle of the
luminaire can be adjusted approximately 90° up or
down in 5° increments.
STEP 2:
To adjust the angle, loosen the four 3/8 – 16 X 1.5"
Socket Head Cap Screws located in the top section
of the Mounting Clamp using the provided 5/16” Hex
Wrench.
STEP 3:
Using the Angle Bracket, shown in
Figure 3,
as a
guide rotate the luminaire to the desired position and
retighten the screws loosened in Step 2 to 120 in.-lbs.
LATERAL ADJUSTMENT
STEP 1:
The position of the luminaire can also be adjusted
laterally. To adjust the Lateral position, loosen the four
3/8 – 16 X 1.5" Socket Head Cap Screws located in the
top section of the Mounting Clamp using the provided
5/16" Hex Wrench. See
Figure 3.
STEP 2:
Remove the Angle Bracket and (2) screws and set aside.
See
Figure 3
STEP 3:
The Angle Bracket can be secured using the existing
holes on the luminaire bar. Set the Mounting Clamp to
desired lateral adjustment using the following positions
on the bar (See
Figure 4)
:
• Position 2 - Left justification.
• Position 4 - Center position (when angle
bracket is on the left side of the mounting
clamp).
• Position 5 - Center position (when angle
bracket is on the right side of the mounting
clamp).
• Position 7 - Right justification.
NOTE:
Positions 1,3,6 and 8 will not be able to be used.
NOTE:
Mounting two luminaires to a 24” Bullhorn
Tenon will require one luminaire mounted in position 2
and one luminaire mounted in position 7.
STEP 4:
Once desired position is achieved reinstall the Angle
Bracket using (2) screws that were removed in Step 2.
STEP 5:
Retighten screws that were loosened in Step 1 to 120
in-lbs.
NEMA
®
RECEPTACLE (OPTIONAL)
STEP 1:
DO NOT loosen/tighten pan head screws for the NEMA
®
receptacle.
STEP 2:
Rotational adjustment of the photo control is tool-less.
STEP 3:
Engage/install photo control into NEMA
®
receptacle on
top of the fixture.
STEP 4:
Firmly rotate photo-control with its photo-eye
approximately in the ‘N’ north direction. Some photo-
controls operate best somewhere between NW and NE.
3
Mounting
Clamp
Angle
Bracket
Angle Markings
Socket Head
Cap Screws
Numbers on angle bracket are shown for illustration purpose
only. Actual bracket doesn’t show numbers.
4
4
3
2
1
8
7
6
5
Angle Bracket is Shown in Position 5 in This Illustration
Mounting Clamp
