2 of 3
LPN00355X0001A1_A
0°
20°
45°
60°
90°
180°
STEP 9:
Make wire connections in Adjustable Fitter Wiring
Compartment per Electrical Connections section on
the back page. Cut leads from the luminaire power
supply cord and re-strip as necessary.
STEP 10:
Replace the Wiring Compartment Cover that
was removed in Step 1 and secure with (3) self-
retaining screws. Torque screws to 23 in-lbs
[2.6 N•m]. Ensure that the o-ring does not get
pinched. See
F
igure 1.
FIXTURE AIMING
STEP 1:
Remove the Wiring Compartment Cover from the
Adjustable Fitter, if necessary, and set cover aside to
reinstall later. See
Figure 1.
STEP 2:
Loosen 7/16” hex bolt in Adjustable Fitter Wiring
Compartment until Adjustable Fitter can be
articulated. It is not necessary to remove this
fastener.
STEP 3:
Adjust the luminaire to the desired aiming angle.
The luminaire may be aimed in 5° increments.
Markings are located on the exterior of the
Adjustable Fitter for ease of aiming. See
Figure 4.
STEP 4:
Upon completion of aiming, torque the 7/16" hex
bolt to 360 in-lbs [41 N•m] and verify that the teeth
are properly aligned and fully engaged. See
Figure 3.
STEP 5:
Replace the Wiring Compartment Cover that was
removed in Step 1 and secure with (3) self-retaining
screws. Torque screws to 23 in-lbs [2.6 N•m].
Ensure that the o-ring does not get pinched. See
Figure 1.
15°
45°
45°
45°
45°
1/2" and 2" (51mm) Adjustable Fitter Positions
4
Major Divisions: 45°
Minor Divisions: 15°
3
