2 of 2
LPN000190_B
www.cree.com/lighting
© 2013 Cree, Inc. All rights reserved. For informational purposes only. Content is subject to change. See
www.cree.com/lighting/products/warranty for warranty and specifications. Cree® and the Cree logo are
registered trademarks.
HOOK AND CORD MOUNT
STEP 1:
Push down on retainer spring until top of spring
is free of luminaire hook. See
Figure 2.
STEP 2:
Slide hook into securely mounted customer
supplied eye hanger and return retainer spring to
original position.
Note:
The luminaire should already be factory set
for correct balance. However, should you need
to, the fixture may be balanced by loosening
the hook adjustment set screw on the top of the
housing and sliding the hook as necessary for
correct balance. Tighten hook set screw when
finished. See
Figure 2.
REFLECTOR INSTALLATION
STEP 1:
Loosen the (4) screws, shown in
Figure 3
, at least
0.1 inch from the heatsink.
NOTE:
The view in Figure 7 is off the underside of
the luminaire.
STEP 2:
Bring trim into housing and line up the (4)
screws from Step 1, with the keyhole slots on the
reflector. See
Figure 4.
STEP 3:
Rotate trim, turn clockwise and tighten the (4)
screws from Step 1. See
Figure 4
.
ELECTRICAL CONNECTIONS
STEP 1:
Make the following Electrical Connections :
a. Connect the black fixture lead to the voltage supply
position of the terminal block.
b. Connect the white fixture lead to the neutral supply
position of the terminal block.
c. Connect the green or green/yellow ground lead to the
green wire position of the terminal block.
LINE
GREEN
LINE-BLACK
GROUND-GREEN
NEUTRAL-WHITE
NEUTRAL
SUPPL
Y WIRING
LUMINAIRE
2
Luminaire Hook
Hook Adjustment
Retainer Spring
3
4
Loosen
Screws
Keyhole
Slots
