CI372X05R1
Page 2 of 3
F1
F2
F3
F4
SENSOR DOOR
F5
INSTALLATION
STEP 1:
Disconnect power to fixture.
STEP 2:
Verify the existing housing model.
STEP 3:
Open and remove lens frame assembly.
Remove door mounting hardware, lamp,
reflector, ballast cover and socket assembly.
Disconnect incoming power leads.
See
Figure 1.
NOTE:
Existing ballast and capacitor may
be left in fixture if they do not interfere with
the LED upgrade module and if the existing
luminaire is not supported solely by the j-box.
If removed, components should be recycled
according to all local, state, and/or federal
ordinances.
STEP 4:
Check the caulk between the Canopy and
the existing luminaire housing. Add caulk as
needed to ensure water tight installation.
STEP 5:
Using the supplied self-tapping screws, attach
the Hinge Mounting Bracket to the existing
housing. See
Figure 2.
STEP 6:
Hang the fixture by the Mounting Bracket with
Hanging Slot on to the previously installed
Hinge Mounting Bracket.
See
Figure 3.
STEP 7:
Make wiring connections per the
“Electrical
Connections”
section.
STEP 8:
After all electrical connections are made,
rotate fixture up and secure in place by
attaching Securement Mounting Brackets to
the fixture housing flange (opposite Hinge
Mounting Bracket) using the supplied self-
tapping screws.
See
Figure 4.
STEP 9:
Attach the Trim Frame over the installed
fixture using the (8) supplied self-tapping
screws.
See
Figure 5.
NOTE:
If installing into a Whiteway Civic,
install spacer between trim frame and fixture.
STEP 10:
Reconnect power to the fixture.
