1 of 2
CI088X02R3_B
THE EDGE
®
LED Area Post Top Mount
Includes: ARE-EDG-R3, R4
INSTALLATION INSTRUCTIONS
INSTRUCTIONS D’INSTALLATION
TO INSTALL:
MOUNTING TO 3" ROUND TENON
STEP 1:
Remove hub cover and pull fixture supply wires through top of
hub. See
Figure 1
.
STEP 2:
Slip fixture hub over pole tenon and route supply wires
through the top of the hub.
STEP 3:
Tenon mounted fixtures are provided with a 3” (77 mm) long
rod. After feeding power supply cord up through round hub,
wrap the upper portion of the cord around the rod and tie into
knot. The rod should then be diagonally inserted into round
hub, and positioned so that it rests on the circular inside
edge of hub. See
Figure 3.
The rod, being held in the hub, will
support the full weight of the power cord running down the
pole, and will relieve any pressure on the connections made
inside the hub.
STEP 4:
Secure the fixture by alternating fastening of eight 3/8”
cup point set screws. See
Figure 2.
Set screws should be
tightened to
120 in-lbs. (13 N-m)
STEP 5:
Make wiring connections per
Electrical Connection
section.
STEP 6:
Replace hub cover that was removed in Step 1 after
completing electrical connections.
DIRECT MOUNT TO 4" SQUARE STEEL SHAFT
STEP 1:
Remove hub cover and pull fixture supply wires through top of
hub. See
Figure 4
on page 2.
1
2
Hub Cover
3/8” Set Screws
NOTES:
1. This carton contains complete fixture and fitter assembly.
2. Tenon mount luminaires used on aluminum, reinforced
fiberglass, or fiberglass poles must be mounted on 3" (77
mm) O.D. tenons.
3. Make electrical connections to input power supply with
appropriately sized (10-18 gauge) wire nuts. Larger wire
nuts will cause interference problems on tenon mount
luminaires.
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be
followed including the following:
READ AND FOLLOW ALL
SAFETY INSTRUCTIONS
1. DANGER
- Risk of shock- Disconnect power before installation.
DANGER
– Risque de choc – Couper l’alimentation avant
l’installation.
2. This luminaire must be installed in accordance with the NEC
or your local electrical code. If you are not familiar with these
codes and requirements, consult a qualified electrician.
Ce produit doit être installé conformément à NEC ou votre code
électrique local. Si vous n’êtes pas familier avec ces codes et
ces exigences, veuillez contacter un électricien qualifié.
SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE
