90
3
５. Slowly turn the crown in the direction of the arrow mark to advance the
moon phase by one until the correct moon phase is displayed.
６. Push the crown back in to the normal position.
Round off the number of the moon phase to the fi rst decimal place.
(Ex.) If the current moon phase is 14.8, set the moon phase to moon phase 15.
Push the crown back in
to the normal position.
※ If the crown of your watch is a screw lock type, lock the
crown. → CROWN on page ７１
Moon phase
15
０ １
Moon phase 0
HOW TO SET THE DATE, TIME, AND MOON PHASE
92
DAILY CARE
4
・This prevents corrosion of the crown and helps to extend the life of the gasket in use.
・ The same practice should be applied to the screw-lock type crown. (No need to pull out
the screw-lock type crown.)
→ CROWN on page ７１
・ Stainless steel is a highly rust-resistant metal. However, rust will form if contaminants
are left on it for a long time.
・ The watch body and band touch the skin directly just as underwear.
Keep the watch body and band clean in order to avoid stain on the sleeve edge or rash
or itch. After removing the watch from your wrist, wipe perspiration or moisture with
a soft cloth as soon as possible.
・Do not use any chemical agent such as cleaner to clean the watch.
●
It is highly recommended for you to take good care of the watch in order to enjoy the
superb quality of the watch for a long time.
● Turn the crown from time to time. (Only several turns in slow movement
will be enough.)
To Preserve the Quality of Your Watch
91
3
Keep in mind the following points in order to set the time more accurately.
TIPS FOR MORE ACCURATE TIME SETTING
・Before setting the time, wind the mainspring suffi ciently.
(Ensure that the power reserve indicator is showing a full-wound state.)
→ How to read the Power reserve indicator on page ７７
・ When starting to use a watch after it stops, wind the mainspring suffi ciently. To set
the time after that, wait for approximately 30 seconds after the small second hand
starts to move, then pull the crown out.
・ Do not stop the second hand movement for longer than 30 minutes. If the stoppage of
the second hand movement exceeds 30 minutes, push the crown back into the normal
position, and wait for at least 30 seconds after the second hand restarts moving, and
then continue the time setting.
HOW TO SET THE DATE, TIME, AND MOON PHASE
WA
TER
RESISTANT 10B
AR
M A
D E
I N
J
A
P
A
N
0
0
0
0
0
18
K
T 7
R
88
-0
A
A
0
93
4
PERFORMANCE AND TYPE
The case back shows the caliber and performance of your watch
Water resistant
performance
Refer to pages
９４ - ９５.
Caliber number
The number to identify
the type of your watch
※ The figure above is one example. Performance of your watch is different from above sample.
Serial Number
The number to
identify your watch
To Preserve the Quality of Your Watch
