6
Section 2
Getting Up and Running
Loading the Battery
Before using the camera, user must load
NP60 rechargeable Li-ion battery.
1. Follow the arrow direction and slide to
eject the battery / SD cover.
2.
Insert the batteries according to the
correct polarity marks (+ or -)
3. Close the battery/SD Card Cover firmly.
Charging Battery
Please fully charge Li-ion Battery via power adaptor for at least ten hours before you use the
camera for the first time.
(1) Plug power adaptor cable into the USB port.
(2) When charging battery, the self-timer LED light keeps blinking. LED light will stay on after
battery charge completes.
(3) It takes three hours to fully recharge the battery each time.
Inserting and Removing an SD Card
（
Optional
）
The camera comes with 32MB built-in memory that allows you to store pictures, movies,
recorded voice and music. You can expand the memory capacity by using an optional SD or
MMC memory card up to 2G. To insert a memory card, refer to the figure above and:
1. Open the battery/SD card cover.
2. Insert the memory card until it locks into position.
To remove an installed SD card, press the card inwards to release it. When the card pops
out, gently remove it from its slot.
Note
When a memory card is fitted, movies and pictures are
saved on card rather than on the built-in memory.
Battery
SD Card
