Configuring Basic Settings 4-4
3. In the
IP Configuration
dialog box that appears, click the arrow next to the
first box and then click the name of your network device to select it. Verify
that your IP address is 192.168.2.xxx and your Subnet Mask is
255.255.255.0.
If they are not, go to steps 4 and 5 below.
4. Click the
Release
button and then click the
Renew
button. Your IP address
and Subnet Mask change to the above values.
5. Click the
OK
button to close the
IP Configuration
dialog box.
Configuring your
wireless client
Your wireless adapter is the wireless equivalent of an NIC. Preparing a computer
on a wireless LAN is, therefore, similar to preparing a computer on a wired LAN.
Before performing the steps presented in "Configuring your wired client" on page
4-2, however, ensure that the wireless settings of your computer’s wireless
adapter match the default wireless settings of your Wireless AP Router, namely:
❑
Operation Mode: Infrastructure
❑
SSID: Network Blaster
❑
Authentication: Open
❑
WEP Mode: Disabled
Refer to the User’s
Guide of your
computer’s wireless
adapter if you need
instructions on
changing its wireless
settings.
Summary of Contents for CW2202
