Step 3: Connect cables to the Platinum Drive
This step only applies if you are installing the Platinum Drive (included with Audigy 2 ZS Platinum).
Component
1.
Internal FireWire (IEEE 1394) cable
2.
Jumper JP1
3.
Power splitter cable
4.
To system power supply unit
5.
Red-colored wire
6.
AD_EXT cable
7.
Black circle on the underside of the cable
8.
Platinum Drive
Warning!
Use the AD_EXT cable ONLY with the Platinum Drive. Do not attempt to use a conventional IDE cable or any other cable with
the Platinum Drive as it may cause electrical shorts and permanent damage to your Audigy 2 ZS audio card, Platinum Drive and
computer. It will also void the warranty for this product.
To prevent permanent damage, use only: the AD_EXT cable with the AD_EXT connector, and the Audigy 2 ZS audio card with the
Platinum Drive.
Do not force any cable into a connector. This can cause permanent damage to your hardware. If it does not fit properly, gently remove
it and try again. Make sure you are connecting to the correct connector, and that the cable is properly aligned with the connector.