WILLIAMSBURG WITH TENT ROOF
19687-100 Rev U (09-20)
© Copyright 2005, Creative Playthings
Assembly
Page 17
ASSEMBLY INSTRUCTIONS
STEP 24 — Right/Entrance Wall Slats:
Find the two Entrance Wall Slats (U) and three Wall Slats (V).
Place one entrance slat 2" from the front right corner post. Fas-
ten the entrance slat to the inside of the right platform side and
right side wall support using four #10 x 1-5/8" screws. Fasten the
other entranceslat 17" from the first entrance slat using four #10
x 1-5/8" screws.
Evenly space the three wall slats between the entrance slat and
the right rear corner post, as shown. The spacing will be approxi-
mately 2". Fasten the Wall Slats using four #10 x 1-5/8" screws
each.
U
V
17"
STEP 25 — Hand Grips:
Fasten the Hand Grips (J) to the entrance wall slats using two 1/4
x 1" hex bolt assemblies each.
The hand grips must be oriented as shown in the illustration,
with the big loop at the bottom.
STEP 26 — Slide Mount:
Place the Slide Mount (K) tight against the front platform end,
centered on the opening left for the slide. Face the beveled edge
of the slide mount toward the inside of the gym. Secure the slide
mount to the platform boards using four #10 x 2-1/2" screws.
Drive the screws until the heads are flush with the top of the
slide mount. Do not over-tighten; over-tightening may cause
the points of the screws to protrude through the bottom of the
platform boards.
K
U
J
#10 x 1-5/8"
Screws
#10 x 2-1/2"
Screws
1/4 x 1-1/2"
Hex Bolts
