WILLIAMSBURG WITH WOOD ROOF
19688-300 Rev R (09-20)
© Copyright 2005, Creative Playthings
Assembly
Page 9
ASSEMBLY INSTRUCTIONS
STEP 2 — Tower Ends:
Lay two post on the ground with the bottoms
next to the spot you want the tower to stand.
Align big holes at the top of the posts face down
and the weld nuts on the inside of the pair of
posts, facing each other.
Arrange the Sandbox End (N) with the blind
holes near the bottom of the posts. Secure The
sandbox end to the bottom of the posts using
four 5/16 x 4" hex bolt assemblies.*
Pre-Assembly Note: The Williamsburg tower is used in many package configurations. Please see the package guide for your
configuration. If your play set will be using a custom layout, there will not be a package guide. In all cases keep your layout in mind
while assembling this tower.
* Note: A Hex Bolt Assembly consists of one Hex
Bolt, one Lock Washer, one Flat Washer and one
Weld Nut.
No Weld Nut
No Weld Nut
Near the middle of the posts secure the
Platform End (W) in the same way. Make sure the
holes along the edge of the board align closer to
the bottom of the posts.
Repeat with the other posts, sandbox end and
platform end.
F
N
W
F
5/16" Weld Nuts
Weld nuts on
the inside faces
5/16 x 4" Hex Bolts
5/16 x 4" Hex Bolts
STEP 1 — Corner Posts and Weld Nuts:
Place the Posts (F) with large holes at the top,
facing up. Align the posts in pairs, one pair will
be at the front of the gym and one at the back.
Insert 5/16" Weld Nuts into the holes down the
upper surface of the posts and the inside surface
of each pair except near the middle. Leave out
the lower hole of the two near the middle on the
inner face.
