© Copyright 2005, Creative Playthings
WILLIAMSBURG WITH WOOD ROOF
19688-300 Rev R (09-20)
Page 18
ASSEMBLY INSTRUCTIONS
STEP 27 — Slide Mount:
Place the Slide Mount (K) tight against the front platform end,
centered on the opening left for the slide. FAce the beveled edge
of the slide mount toward the inside of the gym. Secure the slide
mount to the platform boards using four #10 x 2-1/2" screws.
Drive the screws until the heads are flush with the top of the
slide mount. Do not over-tighten; over-tightening may cause
the points of the screws to protrude through the bottom of the
platform boards.
K
STEP 26 — Hand Grips:
Fasten the Hand Grips (J) to the entrance wall slats using two 1/4
x 1" hex bolt assemblies each.
The hand grips must be oriented as shown in the illustration,
with the big loop at the bottom.
J
U
K
STEP 28 — Slide:
Place the slide in the opening resting on the slide mount,
projecting straight out from the tower. Your slide may have stops
that indicate placement. If so, pull the slide tight against the
platform support. If your slide does not have stops check the un-
derside of the slide to judge how far to overlap the slide mount.
Make sure the holes in the slide are over the slide mount.
Make sure the slide extends out perpendicular from the play set.
Drill 5/16" holes through the slide, slide mount and platform
Boards using the indents in the slide as a guide. Fasten the slide
using one 1/4 x 3" Truss Head Bolt and one 1/4" Weld Nut for
each hole.
STEP 29 — Hole Caps:
Make a final check to make sure all the bolts and screws have been
tightened.
Locate the 1" Hole Caps in the hardware bag. Install hole caps into all
the counter-bored holes to cover and protect the hardware.
Save all instruction sheets and receipts in case it becomes necessary to contact Creative Playthings
for warranty service and/or part replacement. The warranty can be found in your Owner’s Manual.
1/4 x 1-1/2"
Hex Bolts
1/4 x 3" Truss
Head Bolts
#10 x 2-1/2"
Screws
