Assembly
MODEL PS10LIN
19764-100 Rev D (05-10)
© Copyright 2010, Creative Playthings
3DJH
ASSEMBLY INSTRUCTIONS
67(3²/XQFK&RXQWHU6HDW
Fasten the Lunch Counter Seat Supports (O) to the Sand-
box Back (AX) using two 1/4 x 1" Hex Bolt Assemblies each,
as shown.
Attach the Seat Board (AD) to the Lunch Counter Seat Sup-
ports using four 1/4 x 2" Hex Bolt Assemblies.
STEP 20 – Lunch Counter:
Fasten the Table Supports (W) to the rear Corner Posts us-
ing one 5/16 x 3" Lag Screw with one Flat Washer each. Use
the pre-drilled pilot holes in the Corner Posts. Fasten the
Table Braces (C) to the Table Supports using 1/4 x 2-1/2"
Hex Bolt Assemblies, as shown.
Level the Table Supports and swing the Table Braces against
the Corner Posts. Drill a 1/4" pilot hole 1-1/2" deep into the
Corner Posts before attaching them with one 5/16 x 2-1/2"
Lag Screw and one Flat Washer each.
Fasten the two Table Boards (AF) and the Short Table Board
(AS) using four #10 x 1-1/2" Screws each, as shown. Screw
the Table Cleat (AO) to the bottom center of the table as-
sembly using two #10 x 1-1/2" screw into each Table Board.
AD
AX
O
W
G
G
C
AF
AS
AO
67(3²6DQGER[6HDWV
Install the two Sandbox Seats (G) on any two corners of the
base assembly. Use four #8 x 2-1/2" Screws for each Sand-
box Seat. Be careful not to split the Sandbox Sides or Ends.
A 1/8" diameter pilot hole 1" deep is recommended.
