Assembly
CLARKDALE
19966-100 Rev A (04-20)
© Copyright 2018, Creative Playthings
Page 5
ASSEMBLY INSTRUCTIONS
• The instructions found in 63083-554 give a complete description for as-
sembling the play tower with the following exceptions:
• On step 15, the Swing Mount provided is different than the Swing Mount
shown in the manual. The counter-bored holes in the Swing Mount should
face the gym. Secure the bottom of the Swing Mount using the 5/16 x
4-1/2" Hex Bolt Assembly provided. The top hole will not align with the
existing hole. Use a 3/8" diameter drill to make a hole through the top
support and secure using one 5/16 x 4-1/2" Hex Bolt Assembly. (See il-
lustration at right).
• Steps 16 & 17: Use the pre-assembled Access Ladder with plastic steps.
Mount the access ladder to the back of the tower.
• Step 24. Wait to install the wall slats until after installing the monkey bar.
• Mount the Monkey Bar (63082-102) to the front of the tower in the position
shown above.
• Proceed with assembly. On step 25 use the Deluxe Hand Grips rather
than the plastic handles. Hand grips should mount on the back of the set
next to the Access Ladder as shown above.
• Please note the Clarkdale comes with a Scoop Slide rather than the slide
shown in step 28. Installation is the same.
• Assemble the Swing Beam as shown in the instructions in 63059-212 and
mount it to the tower.
• After installing the beam and securing the ground stakes, check to assure
all fasteners are secure.
• Hang the swings and trapeze.
Dimensions of assembled package:
17' 6" wide x 15' 3" deep x 11' 1" tall
CLRKCP4 — Clarkdale 4
Cartons for this Play Set:
1 63098-111 Clarkdale Box 1
1 63083-352 Clayton Box 2
1 63083-554 Posts for Wd Roof (Hdwre & Inst.)
1 63083-555 Clayton Wood Roof
1 8364-400
Scoop Slide 10ft.
1 63061-202 Swing Beam - 3 Pos Premium
1 63059-212 Beam Legs 7ft. (Hdwre & Inst.)
1 31820-102 Swing Mount
1 SH946-102 Access Ladder 5ft. - Premium
1 AA934-204 2 Swings, 1 Ring Trapeze
1 63082-102 Monkey Bar (Hdwre & Inst.)
